Showing all 3D printers.
The bed-flinger you don't regret, in fact another cost probably for another one of this is for AMS.
Instant 800 hours
Never broken any build plates, although I use one from off-brand as a vague excuse
It's time to GO BACK, if you know what I mean.
Not built yet, but I hope I win in building speed run.
Getting in instant 800 hours
Getting in Annex-spec speeds
Voron Serial: V2.3347
Serial Request videoPC: See Rigs/V2.3347 .
MCU: Makerbase Monster8
Upgrades: Voron Tap
Additional mods: OITSWILLIAMV2 150mm, Exhaust Lite, RealEstate, hart.k's 2-piece Stealthburner PCB
Please consider viewing it's specs in rigs page cause it's really an entertaining, surreal yet magical device that amongs with the other great devices
Voron Serial: V0.2378
Serial Request videoSBC: Raspberry Pi CM4
MCU: BigTreeTech Manta M4P + OIWP Non-motion MCU with Pi Pico
Additional mods: OITSWILLIAMV0 Extended skirt, As-is Tophat, Tophat LED, OITSWILLIAMV0 P2, johnncc's Raspberry Pi Camera Mount
SBC: Raspberry Pi 3B+
MCU: Mellow Fly E3 V2
Additional mods: OITSWILLIAMV0 Extended skirt, As-is Tophat, Tophat LED, OITSWILLIAMV0 P2, johnncc's Raspberry Pi Camera Mount
It is Oitswilliam's printer with print dimensions of 300*300mm XY.
Based of Voron Trident with FrankenVoron Tridex.
Unfortunately I don't like using it often, so instant 800 hours on this is not guaranteed, unless if the shaper result is good.